Event to be Held @ Red River Valley Speedway, Fargo ND
June 16th, 2008 @ 7:00pm
Pit Are will open at 12:00pm
If not checked in by 5:00pm there will be a chance you might not run.

1. NO CHYRSLER IMPERIALS, HEARSE, OR PICKUPS.
2. NO Drinking of any Alcohol in pits until event is over.
3. All glass, flammable material and body moldings must be removed.
4. Radiators must remain in Stock position, NO Auxiliary tanks.
5. Any car Bumper may be used, but must remain within family (GM to GM, Ford to Ford, Mopar to Mopar). Bumpers may be welded to the bracket. Bracket may be welded to the frame. (Brackets must remain front to front and rear to the rear. NO exchange of front and rear bumper brackets) Shocks can be compressed and welded. If the bumper is not welded on, bumper chains are MANDATORY.
6. Any make engine/transmission allowed. Engine must remain in stock style location forward of the original firewall, no setbacks. Motor may also be welded or chained in.
7. Trunk Lid/tail gate must be secured with Welding, Chaining, Bolting or Wiring. 6 Spot Maximum. Trunk lid/Tailgate cannot be attached to floor or frame.
8. Hood can be secure in 4 Locations with up to 1” Rod. Front 2 locations may be run to or through Frame. Back 2 Locations must be through the body and not touch frame. Each Header holes in hooded can be bolted in Four Spots Max.
9. Doors may be secured in 6 locations per door with Welding, Chaining, Bolting, or Wiring. If welding patches they must be within a 5” by 5” Plate.
10. Tires must be DOT approved, NO skins will be allowed and air filled only. NO tire in a tire, foam filled or anything other than air will be allowed.
11. Batteries must be removed and placed within the driving compartment of the car.
12. Dash bar and Bar behind the seat are allowed.
13. Gas tank must be boat or race car type tank.
14. Absolutely no Weld to frame except welding in motor and 2 front hood pins.
15. Suspension and frames must remain stock. All body mounts must remain factory and in stock location with the exception of the 2 front cores support mounts may be taken out for hood pins. Chaining of suspension and wiring of coil springs is allowed.
16. All drivers must wear seat belts and helmets during the entirety of their heats.
17. Each car is limited to one fire per heat. 2nd fire car will be disqualified for that heat.
18. Fenders will be allowed to be pre-cut and bolted in 4 spots
19. Transmission coolers are allowed but must be secured well.
20. 2 or 4 door hard tops may run a post and will not count as 1 of the 6 spots per door.
21. Steering May be Modified from steering wheel to steering Sector.
22. Patching of rust will not be allowed. And no window seams can be tacked together.
23. Any pit Person complaining or Yelling at officials will be removed from RRVF Grounds along with Car & Driver.
24. These are the rules and there are no exceptions.

Download Print Version

If you have any questions about rules or anything not in the rules
please contact Jermey @ 701-840-0651 or James @ 701-840-1628.